Running ARM32 (armhf) Packages on ARM64 Systems

Executing an ARM32 (armhf) package on an ARM64 system is feasible by utilizing multi-arch support and compatibility libraries. Below are the general steps for setting up and executing an ARM32 package on an ARM64 system:

1. Enable Multi-arch Support

Ensure that multi-arch support is activated on your ARM64 system by executing the following commands:

sudo dpkg --add-architecture armhf 

sudo apt-get update

2. Install Compatibility Libraries

Install the necessary compatibility libraries for ARM32 using the following command:

sudo apt-get install libc6:armhf

3. Install the ARM32 Package

Proceed with installing the ARM32 package by using the standard dpkg command:

sudo dpkg -i /path/to/arm32_package.deb

4. Resolve Dependencies

During the installation, you might encounter dependency challenges. Use the command below to address any dependencies:

sudo apt-get -f install

Note: While this method is generally effective for many packages, success may vary depending on the specific distribution and package requirements.